Results 1 to 3 of 3

Thread: where must i load CommandFile?

  1. #1
    Senior Member
    Join Date
    Aug 2011
    Posts
    201

    where must i load CommandFile?

    Hi
    I've a shinken install with all monitoring elements into a single host, and multisite installed on second host.
    So, one host to monitor and other host (with multisite mk) to view.
    From mutisite, operator can send some ACK or downtime commands, this is the main purpose to use it.
    My question is, where must I load the CommandFile module.
    As I can see at (very well documented) shinken-specific.cfg lastest version, it can be
    "## Loaded by: Poller, Arbiter, Receiver"
    but i'm not very sure where load it

    update=
    according to http://www.shinken-monitoring.org/wi...patching_works, must be arbiter?

    thanks

  2. #2
    Shinken project leader
    Join Date
    May 2011
    Location
    Bordeaux (France)
    Posts
    2,130

    Re: where must i load CommandFile?

    By default it's the arbiter, but here a receiver is good too, just enable the receiver on this second server, and add the module. The receiver will load the commands, and the arbiter will get it every second and then will dispatch it like it should done if it directly get it with the module itself
    No direct support by personal message. Please open a thread so everyone can see the solution

  3. #3
    Senior Member
    Join Date
    Aug 2011
    Posts
    201

    Re: where must i load CommandFile?

    Hi
    thanks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •